how do i take apart my motorola v120c to add a new full housing?

[Yug]

Hey Peeps,

How do i take apart my motorola v120c to add a new full housing?

[Nokiaman18]

Take it in someplace and have it done so that way if something get's messed up they are liable. Otherwise get yourself a T6 torx and take all the screws out making sure not to lose any of them. Than after you pull the cover off carefully take the circuit board out of the bottom part and place into new back housing. Then make sure that you pay close attention to the way that the mic is mounted in the front face plate on the 120 and remove it and put it into the new cover the same way it was in the old one. then gently remove the speaker out of the old face plate and install that into the new one. Then place the buttons from the old one in the new one unless you prefer the new ones. Then the only thing left to do it to put the phone back toegether and test it all out to make sure that everything is working flawlessly. Test it by making a voice not and making sure that it records the message and that you can here it when you play it back.. Hope that this helps you out.

Panama

[Yug]

Thanks a lot

[tearsonurcheek]

if you have someone do it, make sure they are an authorized moto repair center...otherwise, it voids your warranty

Keep the Faith,

Lance